TP-LINK 54Mbps High Power Wireless Access Point Dokumentacja Pobierz pdf (Strona 64)

Figure 4-56 Speed Test

¾ Destination IP: The Remote device’s IP address.

¾ Advanced options: This is switch to show advanced test options which are used only for

precise estimation.

¾ User: Administrator password of the remote device. It should be filled correctly if you want to

get a precise estimation. Otherwise, keep it blank.

)

Note:

If either User or Password is incorrect, we will take a basic test instead. In other words, none of

the advance options you set will take effect.

¾ Direction: There are 3 options available for the traffic direction while estimating the

throughput.

z transmit-Estimate the outgoing throughput (TX).

z receive- Estimate the ingoing throughput (RX).

z both- Estimate the incoming (RX) first and then the outgoing (TX) afterwards.

¾ Duration: The value you specify here indicate how much time the test should last.

¾ Data amount: The maximal data amount to be sent out during the whole test.

)

Note:

If both Duration and Data amount are specified, the test will stop after any of them is met.

Be sure to click the Run Test button to start a new test after you filled enough information. You

can also stop a running test by click Stop Test button at any time.

4.13.7 Reboot

This page (shown in Figure 4-57) allows you to reboot the router.

1 2 ... 59 60 61 62 63 64 65 66 67 68 69 ... 103 104

Brak uwag

TP-LINK 54Mbps High Power Wireless Access Point Dokumentacja Strona 64